Other /

Where is the Shaker 500 amp located?

Where is the Shaker 500 amp located?

Shaker 500 system: Adds two 8″ dual voice coil woofers located at the mid-line of each door, powered by two amplifiers located in the driver’s kick panel.

Do I need to bypass factory amp?

By bypassing the factory amplifier, the music sounds more detailed and clear than it did when he used the amplifier integration harness. Whenever there’s one available, we recommend bypassing the factory amp to get better sound. If you’re considering a new stereo for your vehicle, keep this option in mind.

What is the difference between a Shaker 500 and 1000?

The 500 is supposed to have 480 watts total output and the 1000 is rated at 1000 watts as far as I have been able to see. The biggest difference is the two big woofers mounted in the trunk on the passenger side. They take up the area behind the wheel well all the way to the back of the trunk.

How do I fix the shaker 500 cd error?

If You have problems with the Shaker 500 CD Player

  1. turn on sterio on am or fm.
  2. press and hold preset #3 and #6 at the same time.
  3. press the #2 preset and it should say dtc codes (that like reading error codes for a check engine light but this is only for the radio)

Can you hook up an amp to factory car stereo?

The best way to connect it to a factory system is to tap into the stereo’s speaker outputs for the amp’s input signal. Then send the amp’s outputs back to the stereo’s harness, and on to the speakers through the factory wiring. These cables will act like a “T-harness” to connect your amp to the factory system.

How do I know if my factory amp is blown?

These are listed below:

  1. There is a noticeable distortion in the sound.
  2. There is no sound even if you have already turned on your audio system.
  3. Your stereo system starts making bizarre sounds such as farting sounds.