Users' questions /

What size is a socket screw?

What size is a socket screw?

All modern sockets have standard size M3. 5 (3.5mm) diameter screws. The lengths can differ, so measure one that you haven’t lost just to be sure. If you’ve lost them both, unscrew one from another nearby socket or switch.

How are socket cap screws measured?

Length is measured from the point at which the head sits flat with the surface, to the tip of the threads. Hex, pan, truss, button, socket cap, and round head screws are measured from right under the head to the end of the threads. Flat head screws are measured from the top of the head to the tip of the threads.

How do you identify a head cap socket screw?

Flat countersunk heads are measured from the top of the head to the tip. The top of the cylindrical head on a socket head cap screw is flat and chamfered, the side may be plain or knurled and the bearing surface is flat. Use a hex key—also called an Allen wrench—or hex bit to drive a standard socket head cap screw.

What degree are flat head socket caps?

Flat head socket cap screw is a type of cap screw with a flat top surface and a conical bearing surface with a head angle of approximately 82 deg. Both hexagon and spline socket types are available for drive.

What are flat head screws?

Flat Head Screws, also called Countersunk Screws, are conical with a flat outer face and a tapering inner face. An advantage to this type of screw is that very little of the head protrudes beyond the surface, allowing it to sink into the material. These screws are commonly made out of stainless steel or zinc coating.

What is Panhead screw?

Pan head screws are a common head type of non-countersunk screw head used in wood screws, self-tapping screws, self-drilling screws, and machine screws. They have wide heads, a flat bearing surface, high vertical, chamfered, or curved sides, and a flat or slightly domed top surface with a recessed socket.

How do I know what size screw I need?

The most important factor in screw selection is length. The general rule of thumb is that the screw should enter at least half the thickness of the bottom material, e.g. 3/4″ into a 2 x 4. The other factor is the screw’s diameter, or gauge.

How do I know what size my screw is?

To measure the diameter of screws and bolts, you measure the distance from the outer thread on one side to the outer thread on the other side. This is called the major diameter and will usually be the proper size of the bolt.

What grade are standard socket head cap screws?

The most common standard Socket Cap Screw is to DIN 912 in 12.9 grade, also available in 8.8 and 10.9 and in A2 and A4 stainless steel.

What is the angle of a flat head cap screw?

82 degrees
Flat Head (82 degrees) – Standard countersunk flat head screw. Allows for flat, smooth surface after installation. Flat Head (Metric) – Metric flat heads screws come standard with a 90 degree head angle.

What to flat head screw look like?

A characteristic of flat head screws is the cone-shaped bearing surface under the head, which in this case in undercut allowing for more threading of short length screws. Flat 100 Head – It uses a 100-degree angle instead of a standard 82-degree angle. These are also used for thinner materials that need a flat head.

What is the angle of a flat head screw?