How do I hook up my water line to my refrigerator?
How do I hook up my water line to my refrigerator?
Instructions
- Turn Off the Water. Locate the fixture shutoff valve on the cold water supply line under the kitchen sink.
- Disconnect the Faucet Water Line.
- Connect the Tee Adapter.
- Connect the Faucet and Refrigerator Supply Tubes.
- Connect the Supply Tube to the Refrigerator.
- Turn on the Water.
Does a fridge need a water line to make ice?
A water line allows you to make ice in your refrigerator. Refrigerators that feature built-in water dispensers or automatic ice makers need to be connected to a water source. Fridges without ice makers or water dispensers don’t need any type of water source to function properly.
How much does it cost to install a water line for a refrigerator?
A typical water line costs between $65 and $170 to run. The cost to install a basic refrigerator on a first floor kitchen with a water line is about $250. If you need an electrical outlet installed by an electrician, you’ll need to pay an average of $220-$750 per outlet.
Does freezer need water line?
There is no need to connect a water line to your chest freezer, as most freezers have built-in water tanks. Also, there is a need for a special outlet and dedicated circuit for your chest freezer. Chest freezers need more electricity and using the wrong outlet cause hazards.
How do you run a flexible water line through kitchen cabinets?
Feed the line through the cabinets, starting where your appliance will sit. Reach inside the cabinets and pull the end through the drilled holes and into the cabinet under the sink. Make sure the line isn’t twisted or kinked as you pull it through.
How do I connect the water line to my PEX ice maker?
First you need to cut the PEX tubing at the access spot. That can be done with a PEX tubing cutter. Then you acquire the correct type fitting (your size requirement may differ from picture) to rejoin the cut PEX with “T” fitting and a branch connection for an added PEX tubing to go off toward the ice maker.
How much does it cost to install an ice maker water line?
Does Lowes install water line for refrigerator?
Appliance Delivery and Connection Lowe’s offers free local delivery and connection of refrigerators, freezers, ranges, washers and dryers to an existing water connection, drain or exhaust vent as long as a new connection kit is purchased from Lowe’s.
What size is an ice maker water line?
1/4-inch
The tubing should have a diameter of 1/4-inch and can be copper line, braided steel line or plastic tubing. Many professionals prefer copper line, but plastic tubing is commonly sold as part of ice maker installation kits.
Do chest freezers require water hookup?
You don’t have to have a water connection for a chest freezer. The power outlet is all you need.
What is the best water line for ice maker?
Copper is the best for water lines to ice makers, use a regular valve teed off a water line then reduced to 1/4 ” do not use saddle valves they leak and come lose and sometimes do not shut off when you need them to. When you bring your copper water line up behind the refrigerator make 4 or 5 loops (like a slinky toy)…
What are some Frigidaire ice maker problems?
Some common problems with Frigidaire ice makers include clogged filters, malfunctioning ice mold thermostats and malfunctioning defrost systems that cause the condenser coils to frost. It is common for the ice-maker assembly to fail after long-term use.
What is a water line connection?
Connect the Water Line to the Supply Valve Attach the water line to the 1/4-inch outlet on the water supply valve and tighten the connector nut with a wrench. If using a piercing valve, once the connection is complete, turn the knob to drive the needle into the pipe and pierce the side, allowing water to flow into the water line.